The effect of bearing congruency, thickness and alignment on the stresses in unicompartmental knee replacements.

Simpson, D; Gray, H; D'Lima, D; Murray, D; Gill, H

Journal article

The effect of bearing congruency, thickness and alignment on the stresses in unicompartmental knee replacements.

Abstract:: BACKGROUND: Unicompartmental knee replacement offers an effective treatment for patients with single compartment knee disease and is becoming an increasingly popular alternative to total knee replacement. An important cause of failure in a unicompartmental knee replacement implant is polyethylene wear. Significant contributory factors to the amount of polyethylene wear are contact stress, bearing alignment, congruency and thickness. METHODS: Four different unicompartmental knee replacement implant designs (Fully-Congruent; Partially-Congruent; Non-Congruent-metal-backed; Non-Congruent-all-polyethylene) were inserted into a validated finite element model of a proximal tibia. The effect that bearing congruency, alignment and thickness had on the polyethylene stresses during a simulated step-up activity for each design was investigated. Additionally, contact pressures were compared to those calculated from Hertz elastic theory. FINDINGS: Only the Fully-Congruent bearing experienced peak von Mises and contact stresses below the lower fatigue limit for polyethylene during the step-up activity. The highest polyethylene contact stresses were observed for the Partially-Congruent and Non-Congruent-metal-backed designs, which experienced approximately three times the polyethylene lower fatigue limit. Increasing the bearing thickness from 3.5mm to 8.5mm of the Non-Congruent design decreased the contact stresses in the bearing; however they did not fall below the lower fatigue limit for polyethylene. Good agreement between finite element and Hertz contact pressures was found. INTERPRETATION: Fully congruent unicompartmental knee replacement bearings can be markedly thinner without approaching the material failure limit, have a greater potential to preserve bone stock and are less likely to fail mechanically.

Publication status:: Published

Actions

Email

Email this record

Send the bibliographic details of this record to your email address.

Your Email
Please enter the email address that the record information will be sent to.

-
Your message (optional)
Please add any additional information to be included within the email.
Cite

Cite this record

APA Style

Simpson, D., Gray, H., D'Lima, D., Murray, D., & Gill, H. (2008). The effect of bearing congruency, thickness and alignment on the stresses in unicompartmental knee replacements. Clinical Biomechanics (Bristol, Avon), 23(9), 1148–1157.

MLA Style

Simpson, D., et al. “The Effect of Bearing Congruency, Thickness and Alignment on the Stresses in Unicompartmental Knee Replacements.” Clinical Biomechanics (Bristol, Avon), vol. 23, no. 9, 2008, pp. 1148–57.

Chicago Style

Simpson, D, H Gray, D D'Lima, D Murray, and H Gill. 2008. “The Effect of Bearing Congruency, Thickness and Alignment on the Stresses in Unicompartmental Knee Replacements.” Clinical Biomechanics (Bristol, Avon) 23 (9): 1148–57.
Share
Print